Фильтр :
Стандарт и/или проект находящийся в компетенции ISO/TC 14 Секретариата Этап ICS
Straight-sided splines for cylindrical shafts with internal centering — Dimensions, tolerances and verification
90.93
Withdrawal of ISO/R 232-1961
95.99
Driving and driven machines — Shaft heights
95.99
Rectangular or square parallel keys and their corresponding keyways (Dimensions in millimetres)
95.99
Taper keys with or without gib head and their corresponding keyways (Dimensions in millimetres)
95.99
Cylindrical and 1/10 conical shaft ends
95.99
Cylindrical and 1/10 conical shaft ends — Addendum 1: Checking of the depth of keyways in conical shaft ends
95.99
Thin parallel keys and their corresponding keyways (Dimensions in millimetres)
95.99
Thin taper keys with or without gib head and their corresponding keyways (Dimensions in millimetres)
95.99
Tangential keys and keyways
95.99
Woodruff keys and keyways
95.99
Straight cylindrical involute splines — Metric module, side fit — Part 1: Generalities
95.99
Straight cylindrical involute splines — Metric module, side fit — Part 1: Generalities
60.60
Straight cylindrical involute splines — Metric module, side fit — Part 2: Dimensions
95.99
Straight cylindrical involute splines — Metric module, side fit — Part 2: Dimensions — Technical Corrigendum 1
95.99
Straight cylindrical involute splines — Metric module, side fit — Part 2: Dimensions
60.60
Straight cylindrical involute splines — Metric module, side fit — Part 3: Inspection
95.99
Straight cylindrical involute splines — Metric module, side fit — Part 3: Inspection
60.60
Straight cylindrical involute splines — Metric module, side fit — Generalities, dimensions and inspection
95.99
Straight cylindrical involute splines — Metric module, side fit — Generalities, dimensions and inspection — Amendment 1: Section three: Inspection
95.99

По запросу ничего не найдено. Пожалуйста, попробуйте изменить настройки фильтра.