Abstract
Specifies the method for determining the ability of wire of diameter or thickness 0,3 to 10 mm inclusive to undergo plastic deformation during reverse bending. The range of diameters of thicknesses for which ISO 7801 is applicable may be more exactly specified in the relevant product standard. The test consists of repeated bending, through 90 in opposite directions, of a test piece held at one end, each bend being over a cylindrical support of a specified radius.
General information
-
Status: PublishedPublication date: 1984-05Stage: International Standard to be revised [90.92]
-
Edition: 1Number of pages: 4
-
Technical Committee :ISO/TC 164/SC 2ICS :77.040.10
- RSS updates
Life cycle
-
Previously
WithdrawnISO 144:1973
WithdrawnISO 2625:1973
-
Now
-
Will be replaced by
Under developmentISO/FDIS 7801