ISO/DIS 2507

This Draft International Standard is in the enquiry phase with ISO members.

Will replace ISO 2507-1:1995 | ISO 2507-2:1995 | ISO 2507-3:1995

ISO/DIS 2507

CHF 65

Convert Swiss francs (CHF) to your currency

Abstract

The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.

General information

Status
: Under development

You can help develop this draft international standard by contacting your national member

Stage
: DIS ballot initiated: 12 weeks [40.20]
Edition
: 3

Number of pages
: 13
Technical Committee :
ISO/TC 138/SC 5

ICS :
23.040.20 23.040.45
RSS updates