Approved Work Item
ISO/AWI 18119
Gas cylinders — Seamless steel and seamless aluminium-alloy gas cylinders and tubes — Periodic inspection and testing
Reference number
ISO/AWI 18119
Edition 2
Approved Work Item
ISO/AWI 18119
89256
A working group has prepared a draft.
Will replace ISO 18119:2018

Abstract

This document specifies the requirements for periodic inspection and testing to verify the integrity of cylinders and tubes to be re-introduced into service for a further period of time.

This document is applicable to seamless steel and seamless aluminium-alloy transportable gas cylinders (single or those that comprise a bundle) intended for compressed and liquefied gases under pressure, of water capacity from 0,5 l up to 150 l and to seamless steel and seamless aluminium-alloy transportable gas tubes (single or those that comprise a bundle) intended for compressed and liquefied gases under pressure, of water capacity greater than 150 l. It also applies, as far as practical, to cylinders of less than 0,5 l water capacity.

This document does not apply to the periodic inspection and maintenance of acetylene cylinders or to the periodic inspection and testing of composite cylinders.

NOTE Unless noted by exception, the use of the word "cylinder" in this document refers to both cylinders and tubes.

General information

  •  : Under development
    : New project registered in TC/SC work programme [20.00]
  •  : 2
  • ISO/TC 58/SC 4
  • RSS updates

Got a question?

Check out our Help and Support