Committee Draft
ISO/CD 7799
Metallic materials — Sheet and strip 3 mm thick or less — Reverse bend test
Reference number
ISO/CD 7799
Edition 2
© ISO 2024
Committee Draft
Under development
A draft is being reviewed by the committee.
Will replace ISO 7799:1985

Abstract

Specifies the method for determining the ability of sheet and strip to undergo plastic deformation in reverse bending. Can be applied to aluminium and its alloys only after previous agreement. The reverse bend test consists of repeated bending through 90 , in opposite directions, of a rectangular test piece held at one end, each bend being over a cylindrical support of specified radius.

General information

  • Status
     : Under development
    Stage
    : Committee draft (CD) registered [30.00]
  • Edition
     : 2
  • Technical Committee :
    ISO/TC 164/SC 2
  • RSS updates

Life cycle

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. ICS
  5. ISO/CD 7799